PosiClean® and FlatClean FC12™ belt assembly – ERO Joint® lacing
The installation method is the same as belts with textile ply
Step 1
To start the assembly:
Need to apply some solution in every hole of each finger on one side of the belt. (This solution can be used as a lubricant and therefore make the assembly easier).
Step 2
Then fit quickly the fingers of joint together. (The lubricant is not drying).
Step 3
Finally, insert the rods in the hole by taking care that the rods stay in the hole and not under the belt, outside fingers.
(It is recommended to use a plank on the belt to keep it and a clamp to push the rod). If the threading of a rod is too difficult, it can be cut to make the thread by the other side of the belt or in the middle of the belt.
Step 4
Please ensure that the rods do not exceed to avoid they cling.
Wipe up any drips of lubricant.
This lubricant is not a dangerous or toxic substance, it is conform to FDA standards.
The belt can be tensioned (like a welded belt), adjusted and the conveyor can start-up.
The implementation solution is a lubricant that will solidify and paste over time.
The solution makes the assembly easier and avoid any migration of the rods outside the operating belt.